Filter
Top Products
Chapter 11 DME Operations
52
DME Special Effect Operations
To set the wedge center position
When Wedge is selected in the <Mode> group, you can set the wedge center
position.
1
Press [Position].
2
Set the following parameters.
Split settings
The Split effect splits the image upper and lower, left and right.
To apply the Split effect
With the Split menu displayed, use the following procedure.
1
In the <Mode> group, select the split method.
Single: Leave gaps between splits.
Double: Fill gaps between splits with the same image.
2
Set the following parameters.
To set the split position
Use the following procedure.
1
Press [Position].
2
Set the following parameters.
5 Phase Partition position −8.000 to +8.000
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 H Horizontal center position −8.000 to +8.000
2 V Vertical center position −6.000 to +6.000
Knob Parameter Adjustment Setting values
1 Transition H Degree of left and right separation 0.000 to 100.000
2 Transition V Degree of top and bottom
separation
0.000 to 100.000
Knob Parameter Adjustment Setting values
1 H Degree of left and right
separation
−4.000 to +4.000