Filter
Top Products
273Setup Relating to DCU
Chapter 16 Engineering Setup
Serial Port Settings (Serial Port Assign Menu)
To set the protocol to match a device connected to a 9-pin serial port, display
the DCU>Serial Port Assign menu.
To display the Serial Port Assign menu
In Engineering Setup, select VF5 ‘DCU’ and HF5 ‘Serial Port Assign.’
The serial port setting status appears in the status area.
Making serial port settings
Use the following procedure.
1
In the DCU>Serial Port Assign menu, select the target for the setting
(DCU1 or DCU2) from the <DCU Select> group.
2
Using any of the following methods, select the serial port.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the selection.
a) The setting value range depends on the DCU port setting.
3
Using any of the following methods, select the protocol for the connected
device.
• Press directly on the list on the right of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the selection.
a) 1. No Assign: nothing is connected to the serial port.
2. P-Bus: P-Bus device.
3. VTR: VTR
4. DDR SD9P: disk recorder (Sony disk 9-pin protocol)
4
Press [Device Type Set].
The selected protocol is reflected on the left of the status area.
Knob Parameter Adjustment Setting values
1 Port No Serial port
1 to max.
a)
Knob Parameter Adjustment Setting values
2 Device Type Protocol selection
1 to 4
a)