Filter
Top Products
Chapter 16 Engineering Setup
228
Setup Relating to Operations From the Control Panel
2
Turn the knob to select the device selection button (DEV1 to DEV12) for
sharing the file list.
3
Press [Same File List Set].
This is reflected in the file list in the status area.
4
Repeat steps 1 to 3 as required to select other devices for sharing the file
list.
Operation Settings (Operation Menu)
To make settings relating to panel operation, use the Panel>Operation menu.
To display the Operation menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF6 ‘Operation.’
The status area shows the items that can be set and a list of the settings.
Setting the on-air tally
To set the high tally state reflected on the control panel, select any of the
following in the <Button Tally> group.
System: The overall system tally state is reflected on the control panel.
Independ: The tally state of the switcher only is reflected on the control panel.
Setting the transition rate display mode
To determine whether to display transition rate values in menus and on the
control panel in frames or as timecode values, select one of the following in the
<Trans Rate Display> group.
Frame: display in frames.
Timecode: display as timecode (SS:FF).
Making settings relating to effects
To make settings relating to the functions used when carrying out keyframe
effect operations, use the following procedure.
1
In the Panel>Operation menu, press [Effect Mode].
The Effect Mode menu appears.
Knob Parameter Adjustment Setting values
2 File List Device selection button for
sharing the file list
1 to 12