Filter
Top Products
Chapter 16 Engineering Setup
254
Setup Relating to Switcher Processor
2
Select the device interface you want to set for the REMOTE3 port from the
<Remote3> group.
Editor A: assign Editor A to the REMOTE3 port.
Editor B: assign Editor B to the REMOTE3 port.
AUX: assign AUX to the REMOTE3 port.
DME1: assign DME1 to the REMOTE3 port.
Note
When REMOTE3 and REMOTE4 are respectively assigned to DME1 and
DME2, you can switch the AUX bus from the DME (DME-3000/7000)
connected to these ports.
At this time, connect the DME input video signals and key signals as
follows.
• DME1 video input: AUX1 output
• DME1 key input: AUX2 output
• DME2 video input: AUX4 output
• DME2 key input: AUX5 output
Note that for a DME external video signal, you can select any of AUX1 to
AUX14 on the DME. Connect to the selected AUX bus.
Making switcher processor GPI input settings
Use the following procedure.
1
In the Switcher>Device Interface menu, press [GPI Input].
The GPI Input menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
3
In the <Trigger Type> group, select the trigger type.
: Apply the trigger on a rising edge of an input pulse.
: Apply the trigger on a falling edge of an input pulse.
: Apply the trigger on a change in the polarity of the input signal.
Knob Parameter Adjustment Setting values
1 Port Port selection 1 to 8
2 No Selection of number for action to be
assigned
1 to 8