Filter
Top Products
241Setup Relating to Switcher Processor
Chapter 16 Engineering Setup
To display the Output menu
In the Engineering Setup menu, select VF3 ‘Switcher’ and HF3 ‘Output.’
The status area shows the signal numbers and names, and output signal phase
for the signals output from Output 1 to 48.
Assigning output signals
To assign a signal to output from an output port, use the following procedure.
1
In the Switcher>Output menu, press [Output Assign].
The Output Assign menu appears.
The status area shows the output ports and assigned signals on the left, and
a list of signals that can be assigned on the right.
2
In the <Output Assign> group, select any of the following.
[Re-Entry Source]: It is possible to make duplicate assignments.
M/E-1 Output 1 to 6
a)
M/E-2 Output 1 to 6
a)
M/E-3 Output 1 to 6
a)
PGM/PST 1 to 6
a)
DME Monitor Video
DME Monitor Key
a) M/E output signals selected in the M/E Output Assign menu.
[Aux Bus]: It is not possible to make duplicate assignments.
Preset
Edit Preview
AUX 1 to 48
3
Using any of the following methods, select the output port number and
signal to be assigned.
• Press directly on the list appearing in the status area to make the
selection.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the selection.
• For output ports not to be assigned, press [Inhibit].
The selected signal appears in reverse video.
Knob Parameter Adjustment Setting values
1 Output No Output port number 1 to 48
2 Source No Selection of signal to be assigned