Filter
Top Products
Chapter 16 Engineering Setup
200
Setup for the Whole System
Selecting the state at start-up
Use the following procedure.
1
In the status area of the System>Start Up menu, select the device to which
the settings are to apply.
2
In the <Start Up Mode> group, select one of the following modes.
Resume: When this is on, Resume mode is enabled.
Custom: When this is on, Custom mode is enabled.
For information about Resume mode and Custom mode, see “System
Setup” in Chapter 1 (Volume 1).
Note
The Resume mode is only valid when a switcher or control panel is
selected for the setting. In this case, the initial status of the control panel
applies only to the key bus delegation button settings.
3
When Custom mode is selected, in each of the <Setup> group and <Initial
Status> group, select one of the following.
User: When this is on, user-defined settings are used for the Setup or
Initial Status settings. For the method of saving the user-defined
settings, see the next item.
Factory: When this is on, factory default settings are used for the Setup or
Initial Status settings.
4
To confirm the settings, press [Execute]. If you want to cancel the setting
changes without saving them, press [Clear].
When [Execute] is pressed, a confirmation message appears.
5
Select [Yes].
The start-up state settings are saved.
Saving user-defined settings
To save the Setup settings
Use the following procedure.
1
After selecting the devices the settings apply to, in the System>Start Up
menu, press [Setup Define].
A confirmation message appears.