Filter
Top Products
63DME Special Effect Operations
Chapter 11 DME Operations
3
To make wave settings for melting part, press [Border] and set the
following parameters.
a) Set when Lock is on.
b) Set when Lock is off.
To stop the waves in the melting part
Press [Lock], turning it on.
With each press, the waves alternately stop and start moving again.
To select the shape of the part beginning to melt
Press [Form] and set the following parameters.
a) 1 (SINE): Sine wave
2 (PARABOLA): Parabola wave
3 (TRIANGLE): Triangular wave
4 (RECTANGLE): Rectangular wave
5 (CIRCLE): Circular wave
6 (CUBIC): Cubic wave
7 (MELT1): Melting wave 1
8 (MELT2): Melting wave 2
To make the melting part stardust
Use the following procedure.
1
Press [Pixel], turning it on.
2
Set the following parameters.
Knob Parameter Adjustment Setting values
1 Amp Amplitude of waves 0.00 to 100.00
2 Freq Frequency of waves 0.00 to 100.00
3
Offset
a)
Amount of wave phase offset −16.000 to +16.000
4
Speed
b)
Direction and speed of waves −100.00 to +100.00
5 Slant Slant of border −100.00 to +100.00
Knob Parameter Adjustment Setting values
1 Form Waveform
1 to 8
a)
Knob Parameter Adjustment Setting values
1 Density Degree to which image
disappears
0.00 to 100.00
2 Random Degree to which pixel positions
become more randomized
further from the center
0.00 to 100.00