Filter
Top Products
Chapter 13 Keyframe Effects
138
Path Setting
The status area reflects the selected path type.
At this point, depending on the setting for Curve, the effect for Hue and
Xpt is also affected as shown in the following table. In the menu, the Hue
and Xpt settings do not change, but the path type indication is dimmed out.
4
If you selected Spline as the path type, set the following parameters, using
the knobs.
Changing the path type for Hue
Use the following procedure.
1
Press the Hue path type indication for the item that you want to change.
2
Turn knob 1 to change the Hue path type.
The path type indications shown in the menu represent the change in hue
as seen on a Vectorscope.
CW: Rotate clockwise.
CCW: Rotate counterclockwise.
Short: The hue changes in whichever of the clockwise and
counterclockwise directions is shorter.
Long: The hue changes in whichever of the clockwise and
counterclockwise directions is longer.
Changing the path type for Xpt
1
Press the Xpt path type indication for the item that you want to change.
A path selection window appears.
Curve setting Hue change Xpt change
OFF Does not change Hold
Step Changes as with the Step setting Is not affected
Knob Parameter Adjustment Setting values
1 Tens Spline interpolation tension –4.00 to +4.00
2 Bias Spline interpolation bias –4.00 to +4.00
3 Cont Spline interpolation continuity –4.00 to +4.00