Filter
Top Products
Chapter 16 Engineering Setup
230
Setup Relating to Operations From the Control Panel
2
In the <Name Display Mode> group, select the method of display in the
source name displays.
Auto: Optimize display according to number of characters. A name of up
to two characters appears as two characters in one line. A name of up
to four characters appears as four characters in one line.
Otherwise, up to the first eight characters are shown in two lines.
2 Character: The first two characters appear.
4 Character: The first four characters appear.
Settings for the Flexi Pad
Use the following procedure.
1
In the Panel>Operation menu, press [Flexi Pad Mode].
The Flexi Pad Mode menu appears.
The status area shows a list of the items with their settings.
2
Make the following settings as required.
Coupling the transition type selection with the Flexi Pad control block
mode selection: To make the Flexi Pad mode selection change
automatically when [WIPE] or [DME] is selected in the transition
control block, press [Wipe/DME Auto Deleg], turning it on.
Button indications in the memory recall section: When the Flexi Pad
control block mode is [WIPE] or [DME], for the button indications in
the memory recall section, select [Pattern] or [Register Name] in the
<Wipe/DME Display> group. When the mode is [Snapshot] or
[Effect], select [Register No] or [Register Name] in the <Snapshot/
Effect Display> group.
For details, see Chapter 5 “Wipes” (Volume 1), Chapter 6 “DME Wipes”
(Volume 1), Chapter 13 “Keyframe Effects” (Volume 2) and Chapter 14
“Snapshots” (Volume 2).
Setting the button operation mode
Use the following procedure.
1
In the Panel>Operation menu, press [Custom Button].
The Custom Button menu appears.
The status area shows a list of the items with their settings.