Filter
Top Products
199Setup for the Whole System
Chapter 16 Engineering Setup
3
In the <Active Line> group, select the number of active scan lines.
Setting the screen aspect ratio
Use the following procedure.
1
In the System>Format>Active Line/Aspect menu, select one of the
following from the <Screen Aspect> group.
• 16:9
•4:3
• Independ
Set the screen aspect ratio separately for M/E, P/P, and USER on the
switcher, and for each channel independently on the DME.
2
If you selected [Independ] in step 1, select from the following.
Switcher Aspect: Make the setting for the switcher.
DME Aspect: Make the setting for the DME.
A menu appears according to the selection.
3
Carry out either of the following, depending on the selection you made in
step 2.
When you selected [Switcher Aspect]: In each of the <M/E-1>, <M/E-
2>, <M/E-3>, <P/P>, and <USER> groups, select either [16:9] or
[4:3].
When you selected [DME Aspect]: For each of the <CH1> to <CH4>
groups, select either [16:9] or [4:3].
Selecting the State After Powering On (Start Up Menu)
To set the initial state at start-up, use the System>Start Up menu.
Note
It is not possible to set the DCU state at start-up, but its settings can be saved
in the control panel.
To display the Start Up menu
In the Engineering Setup menu, select VF1 ‘System’ and HF4 ‘Start Up.’
The status area shows the current start-up mode settings.