Filter
Top Products
231Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
2
Make the following settings as required.
Operation mode of the [ALL] button in the transition control block:
To specify the next transition to be selected by pressing the [ALL]
button in the transition control block, press the next transition you
want to select, turning it on, in the <Next Trans All> group. If
everything here is set to OFF, then pressing the [ALL] button does not
change the specification of the next transition.
Operation mode during an auto transition: For the operation mode
when the [AUTO TRANS], [TAKE] or [FTB] button is pressed once
more during an auto transition, select [Continue] or [Cancel] in the
<Auto Trans/Take> group.
Continue: Continue the auto transition.
Cancel: Cancel the auto transition and return to the state before
starting the auto transition.
Operation mode during keyframe execution: For the operation mode
when the [RUN] button is pressed once more during effect execution,
select [Continue] or [Cancel] in the <RUN> group.
Continue: Continue the execution.
Cancel: Cancel the execution and return to the state before starting the
execution.
Interchanging the [AUTO TRANS] and [CUT] buttons: To
interchange the [AUTO TRANS] and [CUT] buttons in the transition
control block, press the [Auto Trans/Cut Swap] button, turning it on.
[UTIL] button operation mode: To set the operation mode of the [UTIL]
button in the cross-point control block, press either of the following in
the <Util Button> group.
Hold: Acts as a utility button while held down, changing the
assignment of the cross-point button rows.
Lock: For the key rows, each time the button is pressed the cross-point
button assignment toggles between the utility assignment and the
normal assignment. The background A and B rows are fixedly
assigned to the A and B rows, even if the [UTIL] button is pressed.
(For details, see “Names and Functions of Parts of the Control
Panel” in Chapter 2 (Volume 1).)
Transition preview operation mode: For the operation mode of the
[TRANS PVW] button, select [Lock] or [Hold] in the <Trans Pvw>
group. The setting as to whether to use the “One-time mode” in which
the transition preview terminates when the transition completes, or to
use button control, is made on the switcher side (see page 244).
Operation mode of the [XPT HOLD] buttons in the key rows: Set the
operation mode of the [XPT HOLD] buttons in the key rows in the
<Key Bus Xpt Hold> group, as follows.
Normal: The <Xpt Hold Mode> in the Switcher>Key/Wipe/FM
menu is enabled.