Filter
Top Products
283Setup Relating to Router Interface and Tally
Chapter 16 Engineering Setup
Sorting wiring settings
In the Router/Tally>Wiring menu, press [Sort].
Every time you press [Sort], the order of wiring settings changes in the
following order.
Destination lever ordertDestination address ordertSource level order
Tally Generation Settings (Tally Enable Menu)
For settings relating to tally generation, use the Router/Tally>Tally Enable
menu. The settings are common to the parallel and serial tallies.
To display the Tally Enable menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’ and HF4 ‘Tally
Enable.’
The status area shows the tally generation settings.
Making new tally generation settings
Use the following procedure.
1
In the Router/Tally>Tally Enable menu, press [New].
The New menu appears.
2
Turn the knobs to set the following parameters.
a) When you selected Group1 to 4 in the section “Setting the tally groups” (page 280), this is
1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, and 8:G4.
When you selected Group5 to 8, this is 1:R5, 2:G5, 3:R6, 4:G6, 5:R7, 6:G7, 7:R8, and
8:G8. (R is an abbreviation of “Red Tally,” and G of “Green Tally.”)
3
In the <Tally Enable> group, specify the tally generation mode.
Enable: Always generate a tally.
Disable: Never generate a tally.
Tally Input: Generate a tally from the tally input state.
Knob Parameter Adjustment Setting values
1 Destination Address Destination address 1 to 1024
2 Destination Level Destination level 1 to 8
3 Tally Type Tally type
1 to 8
a)