Filter
Top Products
47DME Special Effect Operations
Chapter 11 DME Operations
a) Set when Lock is on.
b) Set when Lock is off.
• When Shape mode is selected
a) Set when Lock is on.
b) Set when Lock is off.
c) 1 (Circle): Circle
2 (Rectangle): Rectangle
3 (Star): Star
4 (Heart): Heart
To limit the direction in which modulation is applied
By pressing [Plus Only], turning it on, you can limit the direction in which
modulation is applied (the direction in which the image expands) to the plus
direction only.
To set the ripple center point
Use the following procedure.
1
Press [Position], turning it on.
2
Set the following parameters, depending on the selected modulation mode.
• When Shape is selected
8
Offset A
a)
Direction along periphery in
which to offset ripple phase and
amount of movement
−8.000 to +8.000
9
Speed A
b)
Ripple direction along periphery
and speed
−100.00 to +100.00
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 Amp R Ripple amplitude 0.00 to 100.00
2 Freq R Ripple frequency 0.00 to 100.00
3
Offset R
a)
Direction in which to offset ripple
phase and amount of movement
−8.000 to +8.000
4
Speed R
b)
Ripple direction and speed −100.00 to +100.00
5 Shape Ripple shape
1 to 4
c)
6 Aspect Ripple aspect ratio −100.00 to +100.00
7 Angle Ripple angle −8.000 to +8.000
Knob Parameter Adjustment Setting values
1 H Ripple center point in
horizontal direction
−5.000 to +5.000