Filter
Top Products
287Setup Relating to Router Interface and Tally
Chapter 16 Engineering Setup
1
In the <Device> group of the Router/Tally>Parallel Tally menu, select
DCU1 or DCU2.
2
Using any of the following methods, select the slot number and port
number.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
3
Press [Set].
The Set menu appears.
4
In the <Source/Destination> group, select the tally type.
Src: Return a tally to all sources output to the destination.
Dest: Return a tally to the destination outputting the source to which a
source tally is returned.
5
Set the destination address and level.
The level setting is only required when in step 4 you selected Destination.
6
When setting the tally type, set the following parameters.
a) When you selected Group1 to 4 in the section “Setting the tally groups” (page 280), this is
1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, and 8:G4.
When you selected Group5 to 8, this is 1:R5, 2:G5, 3:R6, 4:G6, 5:R7, 6:G7, 7:R8, and
8:G8. (R is an abbreviation of “Red Tally,” and G of “Green Tally.”)
7
Press [Execute].
This makes the parallel tally settings, in accordance with the settings in
steps 1 to 6.
Knob Parameter Adjustment Setting values
1 Slot No Parallel tally slot number 2 to 6
2 Port No Parallel tally port number 1 to 54
Knob Parameter Adjustment Setting values
1 Address Destination address 1 to 1024
2 Level Destination level 1 to 8
Knob Parameter Adjustment Setting values
3 Type Tally type
1 to 8
a)