Filter
Top Products
Chapter 11 DME Operations
68
DME Special Effect Operations
For an illustrative figure and other information, see “DME Special Effects” in
Chapter 1 (Volume 1).
Notes
• The trail effect can be applied to two channels at the same time.
• Turning Trail on when Motion Decay or Keyframe Strobe is on turns it off
automatically.
Applying the Trail effect
Use the following procedure.
1
In the DME menu, select VF5 ‘Light/Trail’ and HF2 ‘Trail.’
The Trail menu appears.
2
Press [Trail], turning it on.
The Trail effect is enabled. You can adjust the parameters with the knobs.
3
Set the parameters.
a) 0.00 is no trail. At 100.00, the trail does not disappear.
4
To erase the trail, press [Trail Eraser], turning it on.
Switching the priority between the current image and trail
superimposed
In the <Priority> group, select the method of superimposition.
Over: Current image is on top.
Under: Trail is on top.
Selecting the source to create a trail
In the <Trail Source> group, select the source to create a trail.
Freeze Video: Use freeze images of the input video as source of the trail.
Knob Parameter Adjustment Setting values
1 Decay Degree to which the trail is left
0.00 to 100.00
a)
2 Interval Freeze interval 1 to 255 (frames)
3 Live Proportion of the interval
between two successive freeze
images for which the video is
run
0.00 to 100.00