Filter
Top Products
STAAD Commands and Input Instructions
Section 5
5-18
The SET PRINT 1 command is for eliminating the Zero Stiffness
messages.
The SET SHEAR command is for omitting the additional pure
shear distortion stiffness terms in forming beam member
stiffnesses. With this command you can exactly match simple
textbook beam theory results.
Other rarely used SET commands:
SET DATA CHECK IGNORED
SET RUN IGNORED
SET COMPRESS TURN OFF FILE COMPRESSION
SET SOLUTION INCORE use determinant search for frequencies for small problems
SET SOLVER should ignore
SET CORE should ignore (Memory)
SET EXM should ignore (EXTENDED MEMORY)
SET NJ should ignore
SET NM should ignore
SET CONNECTIVITY should ignore
SET MASS =1 use generated moments as masses.
SET MODAL should ignore
SET THISTORY =2 Use exact force integration in time history.
SET INTERPOLATION Lin or Log for spectra
SET DISPLACEMENT METHOD should ignore
SET ???? ??? file extension for L43
SET BUBBLE =1 do not use bubble fns in solids
SET NOSECT no section results will be calculated
SET TMH should ignore
SET SSVECT to instruct the program to use a different initial set of trial
vectors for eigensolution. May be used if eigen extraction fails.
SET INCLINED REACTION to obtain reactions at inclined supports in the inclined axis
system