Filter
Top Products
Section 5
5-397
2) Member selection can be done only after an analysis has
been performed. Consequently, the command to perform the
analysis has to be specified before the SELECT MEMBER
command can be specified.
3) This command does not cause the program to re-analyze for
results based on the selected member sizes. However, to
maintain compatibility of analysis results with the final
member sizes, you should enter a subsequent PERFORM
ANALYSIS command. Otherwise the post processor will
display the prior results with the revised member sizes.
4) Member group names and deck names are explained in section
5.16 and 5.20.7 respectively.