Filter
Top Products
Section 5
5-417
Design Parameters Cont.
Parameter Default Description
Name Value
TRACK 1.0 1.0 = only numerical output is
provided
2.0 = numerical output and
sketch provided
DEPTH Calculated by
the program
The min. depth of the footing
base slab. Program changes
this value if required for
design.
S1, S2 Calculated by
the program
Size of the footing base slab -
S1 and S2 correspond to
column sides YD and ZD
respectively. Either S1 or S2 or
both can be specified. If one is
provided, the other will be
calculated based on RATIO. If
both are provided, RATIO will
be ignored
EMBEDME
NT
0.0 The depth of the footing base
from the support point of the
column.
PEDESTAL 0.0 0.0 = no pedestal design
1.0 = pedestal design with
program calculating
pedestal dimensions.
X1 X2 - pedestal design with
user provided pedestal
dimensions. X1 and X2 are
pedestal dimensions
corresponding to slab sides S1
and S2 respectively.