Filter
Top Products
STAAD Commands and Input Instructions
Section 5
5-376
General format to print support reactions:
PRI
NT SUPPORT REACTIONS
General format to print story drifts:
PRI
NT STORY DRIFT
Description
The list of items is not applicable for PRINT ANALYSIS
RESULTS and PRINT MODE SHAPES commands.
The PRINT JOINT COORDINATES command prints all
interpreted coordinates of joints.
The PRINT MEMBER INFORMATION command prints all
member information, including member length, member
incidences, beta angles, whether or not a member is a truss member
and the member release conditions at start and end of the member
(1=released, 0 = not released).
The PRINT ELEMENT INFORMATION command prints all
incident joints, element thicknesses, and Poisson ratios for
Plate/Shell elements. The PRINT ELEMENT INFORMATION
SOLID command prints similar information for Solid elements.
The PRINT MEMBER PROPERTIES command prints all member
properties including cross sectional area, moments of inertia, and
section moduli in both axes. Units for the properties are always
INCH or CM (depending on English Inch/Kip/Second or METRIC)
regardless of the unit specified in UNIT command.