Filter
Top Products
Section 5
5-361
f
7
Phase angle in degrees. One phase angle per direction.
Next are the joint forces, if any. Repeat this command as many
times as needed.
*
⎧FX f
1
⎫
⎪FY f
2
⎪
joint-list
⎨FZ f
3
⎬
⎪MX f
4
⎪
⎪MY f⎪
5
⎩
MZ f
6
⎭
FX, FY and FZ specify a force in the corresponding global
direction.
MX, MY and MZ specify a moment in the corresponding global
direction.
f
1
, f
2
... f
6
are the values of the loads.
Notes
• Joint numbers may be repeated where loads are meant to
be additive in the joint.
• UNIT command may be on lines in between joint-list lines
but not within the amplitude data.
The next command, Copy Load, may optionally be placed here to
use the equivalent joint loads from prior cases. This feature
enables using the more complex loading commands like
selfweight, floor load, wind load, etc. that are not directly
available here.
General format:
COP
Y LOAD
i
1
, f
1
, i
2
, f
2
... i
n
, f
n
where,
i
1
, i
2
... i
n
= prior primary load case numbers that are in this
analysis set.