Filter
Top Products
STAAD Commands and Input Instructions
Section 5
5-364
5.37.1.8 Print Steady State/Harmonic Results
PRI
NT HARMONIC DISPLACEMENTS List- spec
⎧(ALL) ⎫
List-spec =
⎨LIST list of items-joints ⎬
⎩
⎭
This command must be after all steady state/harmonic loadings and
before the END STEADY command. For each harmonic frequency
of section 5.37.1.2 the following will be printed:
1. Modal responses.
2. Phase angles with 1 line per selected joint containing the
phase angle for each of the 6 directions of motion.
3. Displacements table with 1 line per selected joint
containing the maximum displacements for each of the 6
directions of motion.
4. Velocities.
5. Accelerations.
STEADY STATE EXAMPLES:
BEGIN STEADY GROUND
STEADY GROUND FREQ 22.4 DAMP .033 ABS
GROUND MOTION X ACC .11 PHASE 0.0
GROUND MOTION Y ACC .21 PHASE 10.0
GROUND MOTION Z ACC .15 PHASE 20.0
PRINT HARMONIC DISP ALL
END
BEGIN HARMONIC GROUND
FREQ FLO 3.5 FHI 33 NPTS 5 MODAL FLIST 4 5 10 -
17 21 30
HARMONIC GROUND DAMP .033 REL
GROUND MOTION X ACC .11 PHASE 0.0
AMPLIT A 0.10 B .21 C 0.03
GROUND MOTION Y DIS .21 PHASE 10.0
AMPLITUDE