Filter
Top Products
STAAD Commands and Input Instructions
Section 5
5-84
The following parameter may be specified by member list. They
only apply to the composite members listed above.
f
13
= concrete width for each composite member listed.
cw-member-list = the list of composite members in
this deck that have this width. Enter as many CW
lines as necessary to define the width of all
composite members of this deck.
This Deck definition data should be entered after the member
properties have been entered.
Notes
1) The DECK definition must start with the START DECK
DEFINITION command and end with the END command.
2) More than one DECK may be specified between the START
and END.
3) The same member number may be included in up to 4
deck/groups. Multiple definitions are useful for output but can
be ambiguous for input data such as constants, section
property, release, etc.
4) If two or more consecutively entered decks have the same
name, then they will be merged. If not consecutive, the second
entry of the same name will be ignored.
5) The _deck-name must be unique within the Deck definitions
and the Group definitions.
6) PER, DIR, OUT are data created by the GUI. Do not edit
this data.
7) This Deck definition data should be entered after the member
properties have been entered.