Filter
Top Products
STAAD Commands and Input Instructions
Section 5
5-420
5.52.3 Footing Design Command
Purpose
This command must be used to execute the footing design.
General Format:
DES
IGN FOOTING ⎧ joint-list ⎫
⎩
( ALL )
⎭
Description
This command may be used to specify the joints for which the
footing designs are required.
Notes
The output of this command may be controlled by the TRACK
parameter (see Section 5.52). If TRACK is set to the default value
of 1.0, only numerical output will be provided. If TRACK is set to
2.0, graphical output will be provided in addition.