Filter
Top Products
Chapter 16 General Device Setup
Vantage Access User’s Guide
208
Figure 141 TR-098: Layer3 Forwarding Table: Details
The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
Table 73 TR-098: Layer3 Forwarding: Forwarding
PARAMETER
NAME
VALUE
Enable This field displays 1 to indicate that entry in the forwarding table is enabled.
A value of 0 means that the rule is disabled. This is the default setting for new
forwarding entries.
Status This field displays the status of the forwarding entry.
Type This field displays the route type.
Default sets the device to route packets with any destination.
Host sets the device to route packets to a specific destination IP address.
Network sets the device to route packets to an IP network.
DestIPAddress This field displays the destination IP address in dotted decimal notation for the
route entry.
DestSubnetMask This field displays the destination subnet mask in dotted decimal notation for
the route entry.
SourceIPAddress This field displays the source IP address in dotted decimal notation for the route
entry.
SourceSubnetMask This field displays the source subnet mask in dotted decimal notation for the
route entry.
ForwardingPolicy This field displays the index number of the forwarding policy the device is to
use.
GatewayIPAddress This field displays the IP address of the gateway in dotted decimal notation for
the route entry.
Interface This field displays the hierarchical name of the WAN interface associated to this
route entry. For example, “InternetGatewayDevice.WANDevice.1.-
WANConnectionDevice.1.WANPPPConnection.1”
ForwardingMetric This field displays the number of hops to the destination. This is associated to
the cost of the route.
-1 means this route is not used to forward traffic.
MTU This field displays the maximum Ethernet packet size allowed on this route.