Filter
Top Products
Chapter 21 WAN Device
Vantage Access User’s Guide
345
21.13.2 Port Mapping Table
Use the PortMapping screen to view the port mapping instance for the WAN IP connection.
Refer to Section 11.2.4 on page 132 for other field descriptions.
1 Select a registered device in the Device List window and click Data Model >
InternetGatewayDevice > WANDevice.
2 Click a number and WANConnectionDevice.
3 Click a number and WANIPConnection.
4 Click a number and PortMapping to display the screen as shown.
RSIPAvailable This field displays whether the Realm-specific IP (RSIP) feature is
supported on the device.
NATEnabled This field displays 1 to indicate that the NAT (Network Address Translation)
feature is enabled for this link; otherwise the field displays 0.
AddressingType This field displays DHCP to set the device to obtain a dynamic IP address
from the ISP for this link on the WAN.
This field displays Static to set the link to use a fixed WAN IP address.
Then configure the fields below.
ExternalIPAddress This field is applicable when you select Static in the AddressingType field.
SubnetMask This field is applicable when you select Static in the AddressingType field.
DefaultGateway This field is applicable when you select Static in the AddressingType field.
DNSEnabled This field displays whether is the device to resolve domain names through
this link.
DNSOverrideAllowed This field displays 1 when a non-empty DNS address is to be replaced by a
DNS entry received on the WAN; otherwise, this field is 0.
DNSServers This field displays the IP address(es) of the DNS server(s). Multiple IP
addresses are separated by a comma.
MaxMTUSize This field displays the maximum size (between 1 and 1540) for the Ethernet
frames allowed on this link.
MACAddress This field is applicable when you select Enable in the
MACAddressOverride field.
This field displays the MAC address on this link.
MACAddressOverride This field displays 1 to change the MAC address of this interface in the
MACAddress field.
This field is 0 if you do not allow MAC address modification.
ConnectionTrigger This field displays how the device will establish a connection for Internet
access. Choices are AlwaysOn, OnDemand and Manual.
RouteProtocolRx This field displays the routing protocol (RIP1, RIP2 or OSPF) the link is to
use. Off means the routing feature is disabled.
ShapingRate This field displays the rate (in bits per second) the device shapes the
outgoing traffic to.
ShapingBurstSize This field displays the burst size (in bytes) for traffic shaping.
PortMappingNumberOfE
ntries
This field displays the number of port mappings on this link.
Table 160 TR-098 Amendment 1: WAN Device: WANIPConnection: Details (continued)
PARAMETER NAME VALUE