Filter
Top Products
Chapter 19 General Device Setup
Vantage Access User’s Guide
288
19.10 Layer2 Bridging
Use the Layer2Bridging screen to configure the bridge settings between layer2 LAN and/or
WAN interfaces on the device.
Select a registered device in the Device List window and click Provision > Data Model >
InternetGatewayDevice > Layer2Bridging.
Figure 228 TR-098 Amendment 1: Layer2Bridging
The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
SourceSubnetMask This field displays the source subnet mask in dotted decimal notation for the
route entry.
ForwardingPolicy This field displays the index number of the forwarding policy the device is to
use.
GatewayIPAddress This field displays the IP address of the gateway in dotted decimal notation for
the route entry.
Interface This field displays the hierarchical name of the WAN interface associated to this
route entry. For example, “InternetGatewayDevice.WANDevice.1.-
WANConnectionDevice.1.WANPPPConnection.1”
ForwardingMetric This field displays the number of hops to the destination. This is associated to
the cost of the route.
-1 means this route is not used to forward traffic.
MTU This field displays the maximum Ethernet packet size allowed on this route.
Table 124 TR-098 Amendment 1: Layer3 Forwarding: Forwarding (continued)
PARAMETER
NAME
VALUE
Table 125 TR-098 Amendment 1: Layer2Bridging
LABEL DESCRIPTION
MaxBridgeEntries This field displays the maximum number of entries in the bridge table.
MaxFilterEntries This field displays the maximum number of entries in the filter table.
MaxMarkingEntries This field displays the maximum number of entries in the marking table.
BridgeNumberOfEnt
ries
This field displays the number of entries in the bridge table.
FilterNumberOfEntri
es
This field displays the number of entries in the filter table.