Filter
Top Products
Chapter 21 WAN Device
Vantage Access User’s Guide
342
Figure 290 TR-098 Amendment 1: WAN Device: WANPOTSLinkConfig
The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
Table 159 TR-098 Amendment 1: WAN Device: WANPOTSLinkConfig
PARAMETER NAME VALUE
Enable This field displays 1 to indicate that the POTS link is active; otherwise it
displays 0.
LinkStatus This field displays the link status (Up, Down, Dialing, Connecting or
Unavailable).
ISPPhoneNumber This field displays the phone number (up to 64 digits in countrycode-
areacode-phone number format) to dial to connect to the ISP. For example,
+86-10-62618501.
Multiple phone numbers are separated with a colon (:).
ISPInfo This field displays a descriptive name (up to 64 characters) to identify this
ISP.
LinkType The default link type is PPP_Dialup.
NumberOfRetries This field displays the number of times (between 0 and 4294967295) the
CPE device is to re-dial for Internet connection.
DelayBetweenRetries This field displays the time (in milliseconds) the CPE device is to wait
before attempting to connect to the ISP again.
Fclass This field indicates the transmission functions the CPE device is capable of.
0:data
1, 2, 2.0: fax
8: voice
80: DSVD
DataModulationSupporte
d
This field displays the modulation method(s) supported for data transfer.
DataProtocol This field displays the protocol(s) supported for data transfer.
DataCompression This field displays the compression method used for data transfer.
PlusVTRCommandSupp
orted
This field indicates whether full-duplex mode is activated on the link or not.