Filter
Top Products
Chapter 21 WAN Device
Vantage Access User’s Guide
330
21.3 WAN DSL Interface Configuration
Use the WANDSLInterfaceConfig to configure the DSL connection for Internet access. DSL
connection setup is independent of other WAN interface parameter settings.
Select a registered device in the Device List window and click Data Model >
InternetGatewayDevice > WANDevice. Click a number and WANDSLInterfaceConfig to
display the screen.
Figure 277 TR-098 Amendment 1: WAN Device: WANDSLInterfaceConfig
The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
Table 150 TR-098 Amendment 1: WAN Device: WANDSLInterfaceConfig
PARAMETER NAME VALUE
Enable This field displays 1 to indicate that the link is active; otherwise, it displays
0.
Status This field displays the link status.
ModulationType This field displays the modulation method used on the link.
LineEncoding This field displays the line encoding method used to establish a connection
to the ISP.
DataPath This field displays whether the link uses fast (lower latency) or interleave
(lower error rate) data path.