Filter
Top Products
Chapter 22 Voice Service
Vantage Access User’s Guide
373
2 Click a number and VoiceProfile.
3 Click a number and RTP.
4 Click RTCP to display the configuration screen.
Figure 321 TR-104: VoiceService: VoiceProfile: RTP: RTCP
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
22.9.2 Voice Profile SRTP Setup
Use the SRTP screen to configure SRTP (Secure Real-time Transport Protocol) settings for
sending voice traffic on the device.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > VoiceService.
2 Click a number and VoiceProfile.
3 Click a number and RTP.
4 Click SRTP to display the configuration screen.
Figure 322 TR-104: VoiceService: VoiceProfile: RTP: SRTP
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
Table 178 TR-104: VoiceService: VoiceProfile: RTP: RTCP
PARAMETER NAME VALUE
Enable This field displays whether RTCP is enabled or disabled.
TxRepeatInterval This field displays the repeat transmission interval (in milliseconds).
LocalCName This field displays the local Cname (canonical name).
Table 179 TR-104: VoiceService: VoiceProfile: RTP: SRTP
PARAMETER NAME VALUE
Enable This field displays whether SRTP is enabled or disabled.
KeyingMethods This field displays the keying methods the device can use.
EncryptionKeySizes This field displays the encryption key sizes the device can use.