Filter
Top Products
Chapter 4 Initial Setup
Vantage Access User’s Guide
96
3 Click Import.
4 When the file import is successful, you can Search for the new entry or entries. The new
devices are not yet registered. To complete the device registration, see Section 4.2.4 on
page 96.
If you cannot see the new entry or entries, check the system logs and make sure the XML
or CSV file format is correct.
Figure 33 Check New Device
4.2.4 Device Setup for Registration
You must configure the managed device to allow remote management from Vantage Access.
Refer to the user’s guide that comes with your compatible device for more information. The
following shows how to enable TR-069 communication protocol between a ZyXEL
compatible device and Vantage Access.
The following describes the steps to configure settings on a ZyXEL compatible device. Steps
may vary depending on your device. Refer to the documentation that comes with your device.
1 To activate TR-069 on the ZyXEL compatible device, access the CLI and enter the
following commands.
2 Once connected to the network, the ZyXEL device automatically locates and registers to
the Vantage Access server.
wan tr load Enables TR-069 configuration.
wan tr active 1 Activates TR-069 remote management.
wan tr acsUrl
172.25.21.174/TR069
Sets the IP address of the Vantage Access server. For example,
172.25.21.174.
wan tr periodicEnable 1 Enables periodic information update to the server.
wan tr informInterval 30 Sets the information update time. For example, 30 seconds.
wan tr debug on Enables TR-069 debug mode to view logs.
wan tr save Saves the settings.
wan tr reset Sets the device to register to the Vantage Access server right away.