Filter
Top Products
Chapter 18 WAN Device
Vantage Access User’s Guide
259
LinkType This field displays the type for this DSL link.
EoA sets the device to use the bridged Ethernet over ATM (RFC2684) link
type.
IPoA sets the device to use the routed IP over ATM (RFC2684) link type.
PPPoA sets the device to use the PPP over ATM (RFC2364) link type.
PPPoE sets the device to use the PPP over Ethernet on bridged Ethernet
over ATM (RFC2516, RFC2684) link type.
CIP sets the device to use the Classical IP over ATM (RFC1577) link type.
Unconfigured means an unknown link type.
AutoConfig This field displays whether the auto-configuration feature is enabled or
disabled for this DSL link.
ModulationType This field displays the type of modulation used on the interface associated
to this DSL link.
DestinationAddress This field displays the destination address for the DSL link. The type of
address you enter varies depending on the connection type.
This field displays the VCI/VPI for a PVC connection.
This field displays an ATM connection name or ATM address for an SVC
connection.
ATMEncapsulation This field displays the encapsulation (LLC or VCMUX) to use for this DSL
link.
FCSPreserved This field displays 1 to include a checksum in the ATM payload for error
correction.
0 means the checksum is not included in the ATM payload. No error
correction is available.
VCSearchList This field displays the VCI/VPI number pairs (separated by a comma) the
link uses to establish a connection if the destination address specified
cannot be reached.
ATMAAL This field displays the ATM Adaptation Layer (AAL) the link uses.
ATMTransmittedBlocks This field displays the number of ATM blocks transmitted successfully.
ATMReceivedBlocks This field displays the number of ATM blocks received successfully.
ATMQoS Select the ATM Quality of Service (QoS) method to use on this link.
ATMPeakCellRate This field displays the peak cell rate (between 0 and 4294967295) for the
upstream traffic in cells per second.
ATMMaximumBurstSize This field displays the maximum burst rate (between 0 and 4294967295)
for the upstream traffic in cells.
ATMSustainableCellRate This field displays the sustainable cell rate (between 0 and 4294967295) for
the upstream traffic in cells per second. This value is used for traffic
shaping.
AAL5CRCErrors This field displays the number of AAL5 layer cyclic redundancy check
errors.
ATMCRCErrors This field displays the number of ATM layer cyclic redundancy check errors.
ATMHECErrors This field displays the number of Header Error Check related errors at the
ATM layer.
Table 106 TR-098: WAN Device: WANDSLLinkConfig (continued)
PARAMETER NAME VALUE