Filter
Top Products
Chapter 23 STB Service
Vantage Access User’s Guide
428
4 Click IP > RTPAVPF to display the screen.
Figure 403 TR-135: STBService: Components: IP: RTPAPVF
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
23.3.15 Front End IGMP Setup
You can view and configure front end IGMP settings in the IGMP screen.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > STBService.
2 Click a number and Components.
3 Click FrontEnd.
4 Click IP > IGMP to display the screen.
Table 235 TR-135: STBService: Components: IP: RTPAPVF
PARAMETER NAME VALUE
Enable This displays whether RTP AVPF receiver report generation is enabled.
Status This displays the status of RTP AVPF receiver report generation.
RetransmitTimeout This displays the time (in milliseconds) the receiver waits for a retransmitted
packet before considering it lost.
MinLossPackets This displays the minimum number of packets the receiver waits before
issuing a retransmission request.
MaxReportTime This displays the maximum time in milliseconds the receiver waits between a
lost packet and the generation of a retransmission request.
MaxLossBurst This displays the maximum number of consecutive lost packets for which the
receiver attempts recovery.