Filter
Top Products
Chapter 23 STB Service
Vantage Access User’s Guide
409
23.2.5 Video Decoder Setup
You can view and configure video decoder settings in the Video Decoder screen.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > STBService.
2 Click a number and Capabilities.
3 Click Video Decoder to display the screen.
Figure 370 TR-135: STBService: Capabilities: Video Decoder
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
23.2.6 MPEG2 Part 2 Setup
You can view and configure MPEG2 Part 2 settings in the MPEG2Part2 screen. This screen
displays supported MPEG2 profiles. It also displays the set of audio standards supported when
MPEG2 Part 2 is used.
1 Select a registered device in the Device List window and click Data Model > Device >
Services > STBService.
2 Click a number and Capabilities.
3 Click Video Decoder > MPEG2Part2 to display the screen.
Figure 371 TR-135: STBService: Capabilities: MPEG2Part2
The following table describes the fields in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
Table 209 TR-135: STBService: Capabilities: Video Decoder
PARAMETER NAME VALUE
VideoStandards This displays the video standards supported by the STB.
Table 210 TR-135: STBService: Capabilities: MPEG2Part2
PARAMETER NAME VALUE
AudioStandards This displays the MPEG2 Part 2 audio standards supported by the STB.
ProfileLevelNumberOf
Entries
This displays the number of profile levels.