Filter
Top Products
Chapter 21 WAN Device
Vantage Access User’s Guide
333
21.4 WAN Ethernet Interface Configuration
You can set the Ethernet settings on the WAN interface in the WANEthernetInterfaceConfig
screen.
Select a registered device in the Device List window and click Data Model >
InternetGatewayDevice > WANDevice. Click a number and WANEthernetInterfaceConfig
to display the screen.
Figure 279 TR-098 Amendment 1: WAN Device: WANEthernetInterfaceConfig
The following table describes the labels in this screen. Refer to Section 11.2.4 on page 132 for
other field descriptions.
CellDelin This field displays the number of cell-delineation errors.
LinkRetrain This field displays the number to link retrain errors.
InitErrors This field displays the number of initialization errors.
InitTimeouts This field displays the number of initialization timeout errors.
LossOfFraming This field displays the number of Loss Of Framing errors.
ErroredSecs This field displays the number of Errored Seconds.
SeverelyErroredSecs This field displays the number of Severely Errored Seconds.
FECErrors This field displays the number of FEC errors.
ATUCFECErrors This field displays the number of FEC errors detected by the ATU-C.
HECErrors This field displays the number of HEC errors.
ATUCHECErrors This field displays the number of HEC errors detected by the ATU-C.
CRCErrors This field displays the number of CRC errors.
ATUCCRCErrors This field displays the number of CRC errors detected by the ATU-C.
Table 151 TR-098 Amendment 1: WAN Device: WANDSLInterfaceConfig: Stats (Total)
PARAMETER NAME VALUE
Table 152 TR-098 Amendment 1: WAN Device: WANEthernetInterfaceConfig
PARAMETER
NAME
VALUE
Enable This field displays 1 to indicate that this interface is active; otherwise, it displays 0.
Status This field displays the status of this interface.
MACAddress This field displays the MAC address of the interface.