Filter
Top Products
6 - 16 6 - 16
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
6.2.2 Accessing procedure
The procedure for making access to the programmable controller CPU using Ethernet
communication will be explained in the following order.
START
Set the Ethernet module switches.
Set the Ethernet module parameters.
Connect the Ethernet module and IBM-PC/AT
compatible.
Edit the HOSTS file. *1
Start the communication setup utility and make
setting on the communication setting wizard.
On the communication test screen, check whether
communication can be made properly.
END
Refer to Section 6.2.1
Refer to Section 6.2.2 (3), (4).
Refer to Chapter 2.
Refer to Section 6.2.2 (6).
Refer to Section 6.2.2 (7).
*1: You need not edit the HOSTS file when entering the IP address in the host name (IP
Address) of the communication setting utility and the ActHostAddress property of the
Ethernet communication control.