Filter
Top Products
6 - 48 6 - 48
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
(2) Checking the MELSECNET/10 board
Check whether the IBM-PC/AT compatible is connected properly to the
MELSECNET/10.
1) Click [Start]-[Program]-[Melsec]-[MELSECNET10 Utility] to
start the MELSECNET/10 utility.
2) Display the "Card information" tab, set as indicated below,
and then click Routing Param. Setting
.
Channel : 51: MELSECNET10 (1 slot)
Mode Setting : 1 On-line automatic return
3) Set the routing parameters and click Set
.
Transfer Target networkNo. : 2
Relay Target NetworkNo. : 1
Relay Target Sta.No. : 2
After that, click the OK
button to close the dialog box.
(To the next page)
4) Click Routing Param. Transfer
to transfer the routing
parameters to the MELSECNET/10 board.