Filter
Top Products
A - 7 A - 7
OPERATING INSTRUCTIONS
This section gives explanation of instructions in the following order.
1) Instructions for used OS and personal computer
2) Instructions for installation and uninstallation
3) Programmable controller CPU-related instructions
4) Instructions for the use of other MELSOFT products
5) Instructions for the use of Ethernet modules
6) Instructions for the use of CC-Link modules
7) Instructions for the use of MELSECNET(II), MELSECNET/10 and MELSECNET/H
8) Instructions for the use of computer link and serial communication modules
9) Instructions for modem communication
10) Instructions for programming
11) Instructions for the use of Microsoft
R
Excel
12) Instructions for the use of Microsoft
R
Access
13) Instructions for the use of VBScript and ASP function
Instructions for used OS and personal computer
(1) When using Microsoft
R
Windows NT
R
Workstation Operating System Version 4.0,
Microsoft
R
Windows
R
2000 Professional Operating System,
Windows
R
XP, Windows Vista
R
or Windows
R
7
Note that the following restrictions apply when a user without Administrator’s
authority operates MX Component.
(a) Communication Setup Utility
• The logical station number cannot be created, changed or deleted.
• Target settings cannot be imported.
• This utility cannot be started up if the communication settings have been
made using MX Component earlier than Version 3.00A. *1
(b) PLC Monitor Utility
• This utility cannot be started up if the communication settings have been
made using MX Component earlier than Version 3.00A. *1
• Device registration cannot be performed on "Entry Device" tab.
(c) Communication board
• Various settings cannot be made on the CC-Link IE Controller Network,
MELSECNET/H, MELSECNET/10, MELSECNET(II), CC-Link, AF and
CPU board utilities.
*1: If the following error message appears, start up and close the utility as a user
with Administrator’s authority, once. This operation enables a user without
Administrator’s authority to start up the utility.
(2) About Ethernet communication, computer link communication and CPU COM
communication on Microsoft
R
Windows
R
95 Operating System
(a) Making Ethernet communication using TCP/IP and UDP/IP on Windows
R
95
of the version older than OSR2 will cause a memory leak. When performing
continuous operation on Windows
R
95, use Windows
R
95 OSR2 or later.