Filter
Top Products
6 - 83 6 - 83
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
6.14 CC-Link IE Controller Network Communication
This section provides the CC-Link IE Controller Network communication procedure
and its setting example using the utility setting type.
6.14.1 Accessing procedure
The procedure for making access to the programmable controller CPU using CC-Link
IE Controller Network communication will be explained in the following order.
START
Set the CC-Link IE Controller Network board.
Connect the IBM-PC/AT compatible to the
CC-Link IE Controller Network.
Start the communication setup utility and make
setting on the communication setting wizard.
On the communication test screen, check whether
communication can be made properly.
END
Refer to Chapter 2 and Section 6.14.1 (2).
Refer to Section 6.14.1 (3).
Refer to Section 6.14.1 (4).
(1) System example
The following system example is used in this section.
1
Access is made to Q06HCPU (No. 1)
at normal station on network No. 1.
Logical station number of "11" is used.
Normal station
Station number 2
IBM-PC/AT compatible (MX Component)
First CC-Link IE Controller Network board is used.
Numeral within indicates station number.
Network No. 1