Filter
Top Products
6 - 75 6 - 75
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
6.12 GX Simulator2 Communication
This section provides the GX Simulator2 communication procedure and its setting
example using the utility setting type.
POINT
The simulation function of GX Works2 cannot be terminated even if stopped by GX
Works2 while connecting to MX Component.
(The simulation function of GX Works2 cannot be terminated even if GX Works2 is
terminated.)
The simulation function of GX Works2 can be terminated after disconnected to MX
Component.
6.12.1 Accessing procedure
The procedure for making access to the GX Simulator using ladder logic
communication will be explained in the following order.
START
END
Start GX Works2 and the simulation function.
Start the communication setup utility and make
setting on the communication setting wizard.
On the communication test screen, check whether
communication can be made properly.
Refer to Chapter 2.
Refer to Section 6.12.1 (2).
Refer to Section 6.12.1 (3).
(1) System example
The following system example is used in this section.
IBM-PC/AT compatible
Q02HCPU
GX Works2
The simulation function
GX Works2
Starting!
Logical station number of "18" is used.
MX
Component