Filter
Top Products
3 - 2 3 - 2
MELSOFT
3 OPERATION PROCEDURES
3.2 User Application Creating Procedures
3.2.1 When using Visual Basic
R
6.0/Visual Basic
R
.NET
The following creation procedures assumes use of Visual Basic
R
6.0/
Visual Basic
R
.NET.
Yes
No
No
Yes
Power on the IBM-PC/AT compatible and start
Windows.
Refer to the operating manual (startup).
Make settings using the
utility setting type?
<Utility setting type>
Start the communication setup utility
and make communication settings
in accordance with the wizard.
Start Visual Basic 6.0/
Visual Basic .NET.
Register the ACT control to Visual
Basic 6.0/Visual Basic .NET.
Create a form and paste the control.
(ActEasyIF control)
Set the property of the pasted
control. (Set only the logical station
number)
Refer to
Section 5.1,
Chapter 6.
Refer to the
programming
manual.
Refer to
Chapter 6.
Perform programming using the functions offered by
the corresponding ACT control.
Perform debugging
using the PLC monitor
utility?
Completion of user application
Refer to the programming manual.
Refer to "Section 3.3 PLC Monitor Utility Operating
Procedure".
<Program setting type>
Start Visual Basic 6.0/
Visual Basic .NET.
Create a form and paste the ACT
controls for corresponding
communication.
Set the properties of the pasted
ACT controls.
Refer to the
programming
manual.
Refer to the
programming
manual and
Chapter 7.
Install MX Component.
Add the ACT controls to Visual
Basic 6.0/Visual Basic .NET.
RR
R
R
R
R
R
R
3