Filter
Top Products
8 - 63 8 - 63
MELSOFT
8 ACCESSIBLE DEVICES AND RANGES
(3) IBM-PC/AT compatible side port: Serial, GOT1000 side port: Serial,
CPU side port: Bus connection
(a) Configuration
IBM-PC/AT compatible
1
Connected
station CPU
Relayed
module
2Relayed network
3
Relayed
module
Relay target
CPU
GOT
Bus
Serial
(b) Accessibility list
The following table indicates whether access can be made or not.
The connected station CPUs are all accessible.
Whether the relay target CPU is accessible or not is indicated by
(accessible) or
(inaccessible).
3. Relay Target CPU
1. Connected Station CPU
(Usable control name)
2. Relayed Network
QCPU
(Q mode)
*
1
Q12DC
CPU-V
LCPU QSCPU
QCPU
(A mode)
QnACPU ACPU FXCPU
Motion
controller
CPU
*
2
CC IE Control
CC IE Field
*
3
*
6
MELSECNET/H
MELSECNET/10
MELSECNET(II)
Ethernet
*
4
*
4
Computer link
QCPU(Q mode)
*
1
(ActGOTTRSP, ActMLGOTTRSP)
CC-Link
*
5
*
5
*
5
*
5
CC IE Control
CC IE Field
*
3
*
6
MELSECNET/H
MELSECNET/10
MELSECNET(II)
Ethernet
Computer link
Q12DCCPU-V
(ActGOTTRSP, ActMLGOTTRSP)
CC-Link
*
5
*
5
*
5
*
5
*1: Inaccessible to Redundant CPU.
*2
: Accessible to the A171SHCPU, A172SHCPU, A173UHCPU(-S1) or A273UHCPU(-S3) only.
*3
: Inaccessible to Q12DCCPU-V relayed by CC-Link IE Field Network since CC-Link IE Field Network is not supported.
*4
: Set the parameter-set values of the target station side Q series-compatible E71 or QE71 to the network number and station number.
Also set the "Station No.
IP information" of the Q series-compatible E71 or QE71 parameter setting.
At that time, specify any of the IP address calculation system, table conversion system and combined system as the "Station No.
IP
information system".
*5
: As the relayed station CPU side CC-Link system master/local module, use the module of software version "S" or later.
*6: Inaccessible to LCPU relayed by CC-Link IE Controller Network since CC-Link IE Controller Network is not supported.
(To the next page)