Filter
Top Products
6 - 30 6 - 30
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
6.3 Ethernet Communication (In case of using Built-in Ethernet port CPUs)
This section provides the procedure for the Ethernet communication with the Built-in
Ethernet port CPU and its setting example using the utility setting type.
6.3.1 Accessing procedure
The procedure for making access to the programmable controller CPU using Ethernet
communication will be explained in the following order.
START
Connect the Built-in
Ethernet port CPU and
IBM-PC/AT compatible.
END
< Connecting to the Ethernet port
directly >
< Connecting by specified Host
(IP address) >
Set parameters of the Built-
in Ethernet port CPU.
Refer to Section 6.3.1 (2).
Edit the HOSTS file. *1
Start the communication setup
utility and set the IP address
on the communication setting
wizard.
Refer to
Section 6.3.1
(4) 3),4).
Start the communication setup
utility and make settings of the
direct connection on the
communication setting wizard.
Refer to
Section 6.3.1
(4) 5),6).
On the communication test screen, check
whether communication can be made properly.
*1: You need not edit the HOSTS file when entering the IP address in the host name
(IP address) of the communication setting utility and the ActHostAddress property
of the Ethernet communication control.