Filter
Top Products
6 - 78 6 - 78
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
6.13 MELSECNET/H Communication
This section provides the MELSECNET/H communication procedure and its setting
example using the utility setting type.
6.13.1 Accessing procedure
The procedure for making access to the programmable controller CPU using
MELSECNET/H communication will be explained in the following order.
START
Set the MELSECNET/H board.
Connect the IBM-PC/AT compatible to the
MELSECNET/H.
Start the communication setup utility and make
setting on the communication setting wizard.
On the communication test screen, check whether
communication can be made properly.
END
Refer to Chapter 2 and Section 6.13.1 (2).
Refer to Section 6.13.1 (3).
Refer to Section 6.13.1 (4).
(1) System example
The following system example is used in this section.
3
24
3 2
1
Access is made to Q06HCPU (No. 2)
at ordinary station (station number: 2)
on network No. 2.
Logical station number of "10" is used.
Ordinary station
Station number 1
IBM-PC/AT compatible (MX Component)
First MELSECNET/H board is used.
Numeral within indicates station number.
Network No. 1 Network No. 2