Filter
Top Products
6 - 53 6 - 53
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
(2) Checking the CC-Link board
Check whether the IBM-PC/AT compatible is connected properly to CC-Link.
1) Click [Start]-[Program]-[Melsec]-[CC-Link Board Utility] to
start the CC-Link utility.
2) Display the "Board Information" tab screen and set the
channel to "81:CC-Link (1)", and set the own station.
Station No. : 1
Station type : Local station
Occupy St. : 4 St.
Link Err X Data : Clear
Baud Rate : 10M
Set the mode to "Hardware test", click Apply
, and check
whether the CC-Link card is normal or not.
3) Set the mode to "Online" and click Apply
.
(Check complete)
4) Display the "Network Monitor" tab screen and make sure
that the loop of the own station is normal.
5) Click Exit
to exit from the utility.