Filter
Top Products
6 - 87 6 - 87
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
(4) Checking the logical station number settings (Conducting a
communication test)
Check whether the CC-Link IE Controller Network communication settings are
correct or not, using the logical station number set in (3).
1) Display the "Target setting" tab screen and
select the logical station number "11".
Check whether the logical station number
settings are correct or not.
2) Display the "Connection test" tab screen and
set the logical station number "11".
Click!
(Communication test complete)
3) Click Test
to check that communication is
being performed normally.
If an error occurred, check the error code and
remove the error.
The error code appears in Result. (At normal
termination, "0x00000000" appears in Result.)
Refer to the programming manual for error
code details.
4) Through the above steps, it is confirmed that
the logical station number settings are correct.
This logical station number is made applicable
by user program creation and PLC monitor
utility.
Collect device data, using this logical station
number.