Filter
Top Products
8 - 60 8 - 60
MELSOFT
8 ACCESSIBLE DEVICES AND RANGES
3. Relay Target CPU
1. Connected Station CPU
(Usable control name)
2. Relayed Network
QCPU
(Q mode)
*
1
Q12DC
CPU-V
LCPU QSCPU
QCPU
(A mode)
QnACPU ACPU FXCPU
Motion
controller
CPU
*
2
CC IE Field
*6
MELSECNET/H
MELSECNET/10
MELSECNET(II)
Ethernet
Computer link
LCPU
(ActGOTTRSP, ActMLGOTTRSP)
CC-Link
*5
*5
*5
*5
CC IE Control
CC IE Field
MELSECNET/H
MELSECNET/10
MELSECNET(II)
Ethernet
Computer link
QCPU(A mode)
(ActGOTTRSP, ActMLGOTTRSP)
CC-Link
CC IE Control
CC IE Field
MELSECNET/H
MELSECNET/10
MELSECNET(II)
Ethernet
*
4
Computer link
QnACPU
(ActGOTTRSP, ActMLGOTTRSP)
CC-Link
CC IE Control
CC IE Field
MELSECNET/H
MELSECNET/10
MELSECNET(II)
Ethernet
Computer link
ACPU,
Motion controller CPU
(ActGOTTRSP, ActMLGOTTRSP)
CC-Link
CC IE Control
CC IE Field
MELSECNET/H
MELSECNET/10
MELSECNET(II)
Ethernet
Computer link
FXCPU
(ActGOTTRSP, ActMLGOTTRSP)
CC-Link
*1: Inaccessible to Redundant CPU.
*2
: Accessible to the A171SHCPU, A172SHCPU, A173UHCPU(-S1) or A273UHCPU(-S3) only.
*4: Set the parameter-set values of the target station side Q series-compatible E71 or QE71 to the network number and station number.
Also set the "Station No.
IP information" of the Q series-compatible E71 or QE71 parameter setting.
At that time, specify any of the IP address calculation system, table conversion system and combined system as the "Station No.
IP
information system".
*5: As the relayed station CPU side CC-Link system master/local module, use the module of software version "S" or later.
*6: Inaccessible to LCPU relayed by CC-Link IE Controller Network since CC-Link IE Controller Network is not supported.