Filter
Top Products
2 - 24 2 - 24
MELSOFT
2 SYSTEM CONFIGURATIONS
3) The following are the CPUs that can be accessed by the
communication drivers.
CPU Type
SW2DNF-CCLINK SW3DNF- CCLINK SW4DNF-CCLINK-B
SW1DNC-
CCBD2-B
A to V *1 W to *2 A to V *1 W to *2 A to V *1 W to *2 -
ACPU (including motion controller CPU)
QCPU(A mode)
QnACPU
QCPU(Q mode)
LCPU
*3
: Accessible, : Inaccessible
*1: For ROM versions "A" to "V" of CC-Link board
*2: For ROM versions "W" and later of CC-Link board
*3: For Version 1.07H or later
4) The CC-Link master station module used should be of
software version "N" or later.
(10) CC-Link G4 communication
NT 95 98 2000 Me XP Vista 7(32) 7(64)
(a) Precautions
1) Computer link communication made on Windows
R
95 will
cause a memory leak. Therefore do not perform
continuous operation.
2) The CC-Link G4 module used should be of software
version "D" or later.
3) The CC-Link master station module used should be of
software version "N" or later.
(b) Switch settings of the CC-Link G4 module
For the switch settings for the use of MX Component, refer to "Section 6.7.1
Switch settings of CC-Link G4 module".
(c) About cables
Communications between the IBM-PC/AT compatible and CC-Link G4
module require the RS-232/RS-422 conversion cables as used in CPU
COM communication.
For more information, refer to "(3) (b) 2) Cables for connection of ACPU,
QnACPU or FXCPU".