Filter
Top Products
6 - 47 6 - 47
MELSOFT
6 COMMUNICATION SETTING EXAMPLES OF THE UTILITY SETTING TYPE
6.7 MELSECNET/10 Communication
This section provides the MELSECNET/10 communication procedure and its setting
example using the utility setting type.
6.7.1 Accessing procedure
The procedure for making access to the programmable controller CPU using
MELSECNET/10 communication will be explained in the following order.
START
Set the MELSECNET/10 board.
Connect the IBM-PC/AT compatible to the
MELSECNET/10.
Start the communication setup utility and make
setting on the communication setting wizard.
On the communication test screen, check whether
communication can be made properly.
END
Refer to Chapter 2 and Section 6.7.1 (2).
Refer to Section 6.7.1 (3).
Refer to Section 6.7.1 (4).
(1) System example
The following system example is used in this section.
Access is made to A2USHCPU-S1 at
normal station (station number: 2)
on network No. 2.
3
24
3 2
1
Logical station number of "5" is used.
Normal station
Station number 1
IBM-PC/AT compatible (MX Component)
First MELSECNET/10 board is used.
Numeral within indicates station number.
Network No. 1 Network No. 2