Filter
Top Products
APP - 2 APP - 2
MELSOFT
A
PPENDICES
(3) Routing parameter setting areas and data
For transient transmission, the routing parameter setting areas depend on the
system.
(a) Two-level system
The routing parameters need not be set because transient transmission is
made to within the same network.
Network No.1
Request
target
Request
source
(b) Multi-level 1 (two networks)
Set the routing parameters only to the station of the request source. *1
To the request source, set the data to access the request target (network No. 2).
Network No.1
Request
source
Network No.2
Request
target
Relay station
(c) Multi-level 2 (three networks)
Set the routing parameters to the request source and relay stations. *1
To the request source, set the data to access the request target (network No. 3).
To the relay station 1), set the data to access the request target (network No. 3).
To the relay station 2), set the data to access the request source (network No. 1).
Network No.1
Request
source
Network No.2
Relay station 1)
Network No.3
Request
target
Relay station 2)
(d) Multi-level 3 (four or more networks)
Set the routing parameters to the request source and relay stations. *1
To the request source, set the data to access the request target (network No. 4).
To the relay station 1) (the nearest relay station to the request source), set the data
to access the request target (network No. 4).
To the relay station 2) (the nearest relay station to the request target), set the data
to access the request source (network No. 1).
To the relay station 3) (relay station other than 1) and 2)), set the data to access the
request target (network No. 4) and request source (network No. 1).
Network No.1
Request
source
Network No.2
Relay
station 1)
Network No.3 Network No.4
Request
target
Relay
station 3)
Relay
station 2)
APP