Filter
Top Products
Adjustment
Tools
For adjustments requiring a nonmetallic tuning tool, use fiber tuning tool, HP part number
8710-0033.
Two different tuning tools may be necessary for IF
bandpass
adjustments, depending upon
the type of tuning slug used in the slug-tuned inductors. If the tuning slug requires a slotted
tuning tool, use HP part number 8710-1010. If the tuning slug requires a forked tuning tool,
use HP part number 8710-0772.
Never try to force an adjustment control. This is especially critical when tuning variable
capacitors or slug-tuned inductors. Required service accessories, with part numbers, are listed
under “Service Kit” in Chapter 1, “General Information.”
Instrument
Service
Position
Refer to Chapter 4, “Assembly Replacement
,”
for information on removing the spectrum
analyzer cover assembly and accessing all internal assemblies.
Adjustment Procedures 2-3